So I just received my ramps 1.4 board not long ago hooked everything up and I installed marlin on it. I am using pronterface to control it. Right now I am just trying to get movement out of my motors so I am using the manual control. I can't seem to get the motor to run consistently. I suspect that it is because of the pulse rate that it is meant for 1.8 degree steppers.
I can't find a spot in the marlin code where I might be able to change the pulse rate. Is this possible in any type of firmware? Any suggestions would help.
I can't find a spot in the marlin code where I might be able to change the pulse rate. Is this possible in any type of firmware? Any suggestions would help.