Hey,
I have a Makerfarm Prusa i3 8". I just replaced the hot end on the machine from a J-head to an E3D and I'm getting nozzle drag. It's can finish prints but I hear it dragging slightly during printing.
I have already tried:
I can't figure out for the life of me why it's dragging. The only other thing is that I upgraded the firmware to the most recent version of Marlin but I don't see why that would be an issue as I transferred everything from the configuration.h file.
Any ideas are appreciated.
Thanks.
I have a Makerfarm Prusa i3 8". I just replaced the hot end on the machine from a J-head to an E3D and I'm getting nozzle drag. It's can finish prints but I hear it dragging slightly during printing.
I have already tried:
- 2 different slicers
- decreasing the flow rate
- leveling the bed
- different z-heights for home
I can't figure out for the life of me why it's dragging. The only other thing is that I upgraded the firmware to the most recent version of Marlin but I don't see why that would be an issue as I transferred everything from the configuration.h file.
Any ideas are appreciated.
Thanks.