Hi all
I just recently got my ormerod assembled, and after some struggling with calibrating the beast it printed some parts flawlessly.
But now it has started to rebel against me I believe. For some reason the extruder after a few seconds of printing starts reversing and pulling the filament out. It keeps on "printing" but without any material.
So after a while the filament again reaches the nozzle and it prints some more, just to once again feed backwards.
I have now tried everything i can think of, updating firmware, recalibrating, tried different settings in slic3r, but to no avail.
If anyone has an idea on how to fix this it would be greatly appreciated.
/J
I just recently got my ormerod assembled, and after some struggling with calibrating the beast it printed some parts flawlessly.
But now it has started to rebel against me I believe. For some reason the extruder after a few seconds of printing starts reversing and pulling the filament out. It keeps on "printing" but without any material.
So after a while the filament again reaches the nozzle and it prints some more, just to once again feed backwards.
I have now tried everything i can think of, updating firmware, recalibrating, tried different settings in slic3r, but to no avail.
If anyone has an idea on how to fix this it would be greatly appreciated.
/J