I'm printing on a G1 mix, with Z,Y,Z and E properly calibrated as far as I can tell.
As an example, the attached print is about 23mm high. The walls are 3 mm. Boy do they come out bad.
Will cooling help something like this? I notice when the extruder comes about to a previous position, the wall is still soft and moves around with it.
I am printing at 235C and bed at 120C.
As an example, the attached print is about 23mm high. The walls are 3 mm. Boy do they come out bad.
Will cooling help something like this? I notice when the extruder comes about to a previous position, the wall is still soft and moves around with it.
I am printing at 235C and bed at 120C.