Hello, I have just completed putting together an i3 Prusa with sanguinololu 1.3a and Marlin firmware. Are there specific settings regarding the microstepping jumper settings? I am having trouble with the x and y motors, but specifically the y motor behaving erratically. Occasionally I get the y bed to move correctly after multiple adjustments to the jumpers but then the x motor gives me trouble.
On top of this, in Pronterface I get errors every now and then including a loss of control of the hotend and it's thermistor but then after some time it might reconnect by itself.
Also, Pronterface seems to lose communication with the printer at times or freezes, not sure but this usually occurs when the y motor moves erratically.
Anyone have some suggestions?
(apologies for the lack of introduction)
On top of this, in Pronterface I get errors every now and then including a loss of control of the hotend and it's thermistor but then after some time it might reconnect by itself.
Also, Pronterface seems to lose communication with the printer at times or freezes, not sure but this usually occurs when the y motor moves erratically.
Anyone have some suggestions?
(apologies for the lack of introduction)