First Print Issues on Prusa i3 (4 replies)

Hi! I just printed my first calibration piece and attached is the result I got. I am using PLA plastic my hot end temp is set to 192 C and the bed at 60 C. I am using 3mm filament and extruding at 0.4. When the print starts and it prints the first couple layers it looks good but then it seems as if the whole right side does not print good then it just gets worse as you can see in the photos. While the printing is going my Z motors are making a ticking sound while they are stationary then once they move the ticking stops and they move fine. Anyone having a similar issue. Any help would be greatly appreciated.


Thanks

Pat Di Sarro