Quick questions.
Can the ramps set up with pololu stepper drivers run three or four stepper motors at the same time with out over heating.
It can obviously run the 2 for the z axis (but these are only used intermittently).
Reason I am asking is that I would like to have multiple extruders running at the same time to print multiple small items (obviously identicel items).
Is it possible with basic rep rap electronics, or do a need a beefier set up.
Thanks for any advice.
Can the ramps set up with pololu stepper drivers run three or four stepper motors at the same time with out over heating.
It can obviously run the 2 for the z axis (but these are only used intermittently).
Reason I am asking is that I would like to have multiple extruders running at the same time to print multiple small items (obviously identicel items).
Is it possible with basic rep rap electronics, or do a need a beefier set up.
Thanks for any advice.