I'm using an old version of Slic3r, version 0.7.1 and would like to upgrade to the current version. I have been working on two INI files for two different filaments for quite a while and am very close to having them perfect. I was just wondering if I can load those INI files in the new version or if I would have to recreate them?
I did try this and they did load, even a quick check of the settings looked ok, but something was obviously different since it did not print nearly as good as it does when I use the old version. Is there a way to convert it to make it load fully or do I have to just type it in again? Thank you,
Bob
I did try this and they did load, even a quick check of the settings looked ok, but something was obviously different since it did not print nearly as good as it does when I use the old version. Is there a way to convert it to make it load fully or do I have to just type it in again? Thank you,
Bob
