New problem - Motors don't move after fixing end stops (1 reply)

Greetings all,

Thanks again to those who helped me work out the end stop issue. Putting one
end-stop per axis in the proper place allowed the end stops to return correct values
with M119.

Thing is, once I got this problem solved a new problem developed. The motors
stopped moving all-together. I tried inverting the end stops thinking it may have
appeared that the stops were triggered (haulting the motors), I checked the supply
(changed it actually to a better one) and triple-checked the soldering on the RAMPs
board. The problem seems to have started after re-soldering the end-stop block,
so I looked for any soldering archs carefully. Still no luck. I see through one of the
holes on the ramps board a yellow light on arduino triggering every time I try to move a motor
(I recall seeing a green when the motors were driving ok)

No magic smoke. Nothing that would lead me to believe the board is fried.
But if it were fried, is it possible the fuse (The flat orange thing near the power
rail, I believe) is blown?

I've tried everything I can think of. If any of you kind reprappers have a thought
on my issue, I'd appreciate the help.

Charlie