Slic3r Help! (1 reply)

Hello everyone!

I need some help with my g-code generator Slic3r.
As you can see from the picture attached, I've loaded a 5 mm X 5 mm X 5 mm cube to Slic3r.
But for some reason, it seem to consider the cube to be flat!
I needed to increase the scaling to 1000% (which I shouldn't need to)
But still it only says the size of the print is 0 X 0 X 5 mm.
And yet the volume is 125 mm cubed.
What is going on???

Thanks for the help!

LogicalThinking