Hello, I have just finished building my Reprap Prusa Mendel i2, and I have found a problem with my extruder
I have calibrated all the home points accurately, but when I print, the print is just a tangled mess of plastic.
I am thinking that there is a problem with my extruder- that it has two holes in it, but I am not too sure.
So here are my questions:
1. DO I have two holes in my extruder? (please refer to attatched photos, and apology for bad pic)
[attachment 25867 UploadIt.jpg] ------------------- [attachment 25868 FirstCreationSupposedtobeaHaloAssaultRifle.jpg]
2. If my extruder is fine, then what are the possible problems and solutions to it?
3. If my extruder is faulty, then where can I complain to, and how can I replace it?
4, How do I improve my quality?
Thankyou very much in advance.
I have calibrated all the home points accurately, but when I print, the print is just a tangled mess of plastic.
I am thinking that there is a problem with my extruder- that it has two holes in it, but I am not too sure.
So here are my questions:
1. DO I have two holes in my extruder? (please refer to attatched photos, and apology for bad pic)
[attachment 25867 UploadIt.jpg] ------------------- [attachment 25868 FirstCreationSupposedtobeaHaloAssaultRifle.jpg]
2. If my extruder is fine, then what are the possible problems and solutions to it?
3. If my extruder is faulty, then where can I complain to, and how can I replace it?
4, How do I improve my quality?
Thankyou very much in advance.