I'm using OctoPrint to control my Prusa i3 throught a Raspberry Pi and everything is working fine except that it seems to be sending heaps of data over the network.
I logged on with my iPhone for about 10 minutes and it used over 600Mb. Is this usual behaviour? Is there anyway to reduce this?
I did have the stream from the webcam up for about 1 minute but even just the main screen showing the temperature graph seems to be using 20-30Mb per minute.
I logged on with my iPhone for about 10 minutes and it used over 600Mb. Is this usual behaviour? Is there anyway to reduce this?
I did have the stream from the webcam up for about 1 minute but even just the main screen showing the temperature graph seems to be using 20-30Mb per minute.