heater,thermistor not work (3 replies)

Repetier, hi,

I am using Lambo board, honeywell thermistor.
I had built my 3d printer 1 month ago, but i can't operate it until now.
I have uploaded Repetier firmware, but x,y,z axis work correctly except EXR0_heater and thermistor.
I modified Repetier firmware as below
#define MOTHERBOARD 301
#define EXT0_TEMPSENSOR_TYPE 5
#define NUM_TEMPS_USERTHERMISTOR0 67
#define USER_THERMISTORTABLE0 {\
{1*4, 941*8},{19*4, 362*8},{37*4, 299*8},\
{55*4, 266*8},{73*4, 245*8},{91*4, 229*8},{109*4, 216*8},{127*4, 206*8},{145*4, 197*8},{163*4, 190*8},{181*4, 183*8},{199*4, 177*8},\
{217*4, 171*8},{235*4, 166*8},{253*4, 162*8},{271*4, 157*8},{289*4, 153*8},{307*4, 149*8},{325*4, 146*8},{343*4, 142*8},{361*4, 139*8},\
{379*4, 135*8},{397*4, 132*8},{415*4, 129*8},{433*4, 126*8},{451*4, 123*8},{469*4, 121*8},{487*4, 118*8},{505*4, 115*8},{523*4, 112*8},\
{541*4, 110*8},{559*4, 107*8},{577*4, 105*8},{595*4, 102*8},{613*4, 99*8},{631*4, 97*8},{649*4, 94*8},{667*4, 92*8},{685*4, 89*8},\
{703*4, 86*8},{721*4, 84*8},{739*4, 81*8},{757*4, 78*8},{775*4, 75*8},{793*4, 72*8},{811*4, 69*8},{829*4, 66*8},{847*4, 62*8},\
{865*4, 59*8},{883*4, 55*8},{901*4, 51*8},{919*4, 46*8},{937*4, 41*8},\
{955*4, 35*8},{973*4, 27*8},{991*4, 17*8},{1009*4, 1*8},{1023*4, 0}}

I don't use heat bed.
When my pc connect to 3d printer, temperature is 58 deg C,and EXT0 heater do not work.
Repetier-host shows "extruder0 : work, heated bed : temp sensor defect, printer set into dry run mode until restart!".

What should i modify in firmware?
Please give me an answer.