I am using a windows vista machine and when I connect up the duet board to the machine it comes up with a message "USB device not recognised. One of the USB devices attached to your computer has malfunctioned, and Windows does not recognize it." I only got up to the stage 'Commissioning' in the instructions so I haven't been able to print anything yet. It did connect once or twice and I got the message "Temperature measurement fault on heater 1, T = -273.1" so I replaced the thermistor, after that work for a while and then stopped. I didn't even get the chance to load the firmware.
I have looked online for solutions to the same message and tried a few, like rebooting the system, but they all haven't worked. I am going to try a windows 7 machine soon which I hope may fix it. Do you think it could be a problem with the Duet board or have I got a problem with the drivers?
Thanks
Ben
I have looked online for solutions to the same message and tried a few, like rebooting the system, but they all haven't worked. I am going to try a windows 7 machine soon which I hope may fix it. Do you think it could be a problem with the Duet board or have I got a problem with the drivers?
Thanks
Ben
