I was wondering why the plate doesn't run to y motor upon Y Homing.
The macro for Y Homing contains the line: G1 Y220 F2000 S1
Just checked this command in Pronterface and it is being ignored!
If I skip the S1 and send G1 Y220 F2000, it certainly moves to the endstop but overruns it.
I tried with G91 before and G90 before, but no luck in both cases.
The macro for Y Homing contains the line: G1 Y220 F2000 S1
Just checked this command in Pronterface and it is being ignored!
If I skip the S1 and send G1 Y220 F2000, it certainly moves to the endstop but overruns it.
I tried with G91 before and G90 before, but no luck in both cases.