Hi, I'm new to all this, but learning fast.
Ok I've got a step closer but if you look at the picture you'll see my gear isn't going to cut it.
I have two problems.
1) the in fill (you can see through it. So I stopped it).
2) is a printer setting problem I think, in those stray full on strands that haven't stuck in the holes.
If any one has a working gcode of the extruder drive gears could you attach them please, as I'm sure if I don't get them printed soon I need them when I can't print them.
I know the printer is good as it's printed some really good prints. So its my slic3r settings, and temps.
Thanks
Kim..
Ok I've got a step closer but if you look at the picture you'll see my gear isn't going to cut it.
I have two problems.
1) the in fill (you can see through it. So I stopped it).
2) is a printer setting problem I think, in those stray full on strands that haven't stuck in the holes.
If any one has a working gcode of the extruder drive gears could you attach them please, as I'm sure if I don't get them printed soon I need them when I can't print them.
I know the printer is good as it's printed some really good prints. So its my slic3r settings, and temps.
Thanks
Kim..