I have updated the commissioning instructions - [www.reprappro.com]
I've been getting a lot of emails from people with proximity probe problems, homing problems, pronterface problems, network problems etc, which mostly boil down to not realising that the SD card sys/config.g file MUST be read at startup. So I've updated the commissioning instructions to point this out, and give some pointers if it's not working. I've also updated the 'update your firmware' section, to try and encourage people to check and update their firmware, which can also help solve these problems.
Can inexperienced and experienced users alike take a look, and tell me if it looks sensible? Does it need more?
Ian
RepRapPro tech support
I've been getting a lot of emails from people with proximity probe problems, homing problems, pronterface problems, network problems etc, which mostly boil down to not realising that the SD card sys/config.g file MUST be read at startup. So I've updated the commissioning instructions to point this out, and give some pointers if it's not working. I've also updated the 'update your firmware' section, to try and encourage people to check and update their firmware, which can also help solve these problems.
Can inexperienced and experienced users alike take a look, and tell me if it looks sensible? Does it need more?
Ian
RepRapPro tech support