Dear RepRappers
I'm almost finished building my RepRap i3 and am a bit lost on the next steps to get my printer actually printing. I am confused on which software I should be using and calibrating my machine, while there is plenty of resources online it can get a bit overwhelming. If anybody could give me a nudge in the right direction it would be greatly appreciated. I have included a picture of my machine for reference, I'm using Marlin for the LCD panel. Thank you for taking the time to read my post.
Kind Regards
William
"https://www.dropbox.com/s/om022gjac51stsu/2014-01-16%2016.59.06.jpg"
I'm almost finished building my RepRap i3 and am a bit lost on the next steps to get my printer actually printing. I am confused on which software I should be using and calibrating my machine, while there is plenty of resources online it can get a bit overwhelming. If anybody could give me a nudge in the right direction it would be greatly appreciated. I have included a picture of my machine for reference, I'm using Marlin for the LCD panel. Thank you for taking the time to read my post.
Kind Regards
William
"https://www.dropbox.com/s/om022gjac51stsu/2014-01-16%2016.59.06.jpg"