Having solved my SD card problems, I could see my latest print shapping up nicely. However when It was done I noticed a slight problem in the Y direction.: ( the wall is meant to be straight)
[attachment 24888 Photo0029.jpg]
If you look at the part from the pther angle you can see the problem starts where the wall gets thin:
[attachment 24889 Photo0031.jpg]
I'm wondering if it would improve if I decrease the Yacceleration?
regards
Andy
[attachment 24888 Photo0029.jpg]
If you look at the part from the pther angle you can see the problem starts where the wall gets thin:
[attachment 24889 Photo0031.jpg]
I'm wondering if it would improve if I decrease the Yacceleration?
regards
Andy