I'm having a problem with Slic3r - I can't see anything wrong with the STL file and Slic3r is not consistent in how it messes up this part.
Here is a screenshot showing the G-code - the two flat panels are the exact same model, but you can see on one slic3r has added a layer over the cross shape on one end. When trying to print the parts solo, I found in one orientation it had problems and if I spun it 90 degrees on the Z axis then it sliced correctly. With this plate containing all parts I have been unable to get it to slice both of the flat plates correctly.
![fUoMNza.png]( "fUoMNza.png")
Seems bizarre no? Any idea why it is doing this?
Here is a screenshot showing the G-code - the two flat panels are the exact same model, but you can see on one slic3r has added a layer over the cross shape on one end. When trying to print the parts solo, I found in one orientation it had problems and if I spun it 90 degrees on the Z axis then it sliced correctly. With this plate containing all parts I have been unable to get it to slice both of the flat plates correctly.
Seems bizarre no? Any idea why it is doing this?