A very good day, first off all: happy new year!
Finally i found some time to work on my 3d-Printer and after all the soldering work was down i tried to connect the printer to my laptop. (as seen here: [imgur.com]) First time connecting i get the message that the Atmega1284P is recognize, but that the driver couldnt be found, then after trying it a second time i get the message that the "usb device is not recognized". What did i do wrong? Do i have to install some drivers?
Sorry for being such a noob on all this, but thank you for you cooperation!
A very good day and again thank you for helping this forum
Finally i found some time to work on my 3d-Printer and after all the soldering work was down i tried to connect the printer to my laptop. (as seen here: [imgur.com]) First time connecting i get the message that the Atmega1284P is recognize, but that the driver couldnt be found, then after trying it a second time i get the message that the "usb device is not recognized". What did i do wrong? Do i have to install some drivers?
Sorry for being such a noob on all this, but thank you for you cooperation!
A very good day and again thank you for helping this forum