I managed to salvage some Applied Motion HT17-075 Stepper Motors at work to use in my RepRap Prusa build I am engaged in. However I am not clear how these wire to my new RAMPS 1.4.
See Applied Motion HT17-075 for more info.
It is an eight wire stepper which can be wired as Bipolar Parallel, Bipolar Series, or Unipolar. Unipolar requires a common that does not appear to be available on the board.
The RAMPS 1.4 Wiring Wiki references "From left to right, wire all of the stepper motor's wires as red, blue, green, and black or red, green, yellow, blue into the pins next to the Pololus" but my motors don't have all these colors.
Thoughts?
Derek
See Applied Motion HT17-075 for more info.
It is an eight wire stepper which can be wired as Bipolar Parallel, Bipolar Series, or Unipolar. Unipolar requires a common that does not appear to be available on the board.
The RAMPS 1.4 Wiring Wiki references "From left to right, wire all of the stepper motor's wires as red, blue, green, and black or red, green, yellow, blue into the pins next to the Pololus" but my motors don't have all these colors.
Thoughts?
Derek