Print Stopping on Leapfrog Creatr (1 reply)

On my Leapfrog Creatr using Repetier, my prints stop in the middle of G-code, sometimes multiple times depending on the part size. It seems to happen most often at high- acceleration points, but turning down the acceleration control to as low as 250 mm/s/s doesn't solve the stoppages.

I can resume the print by pressing the "fake" OK button in the debug window. I have tried different computers and shielded USB cables, but nothing seems to work.

I have my baud rate set at 115200, and was wondering if this might be a contributor. However, the printer was working beautifully for 2 months with this baud rate.

Does anyone have an idea as to what causes this, and possible solutions to the problem?

I just want to get my printer working properly, it's been doing this for over 3 weeks and I need it to be running properly to produce parts for my company.

Please help!