Ormerod commisioning problem (4 replies)

Hi

I have followed instructions and got to the point where i was changing the settings in the config.g file for the axis compensation.

I changed the config.g file and copied on to the SD card , now I can't access the printer via Pronterface.

I get the following:-

I get a message saying this - could not open port /dev/tty.usbmodem2641: [Errno 16] Resource busy: '/dev/tty.usbmodem2641'
and then the screen continually scrolls with the temperatures of the bed and the head.


I am using a Mac book pro

thanks for your help

Paul