Hi!
I have problems with my infill, see the attached picture. In the picture, it already printed 3 layers. You can see the holes in it. What I think is remarkable, the holes are always at the same position, on every layer, which means that it is not a problem of lost steps (otherwise it would not hit the inner circle this perfectly). Of course, "regular" infill does not have to fill the whole layer, but - in my understanding - the top and bottom layer should be completely filled. I'm using repetier host and firmware and slice with slic3er. The settings is 0.4mm, the filament 3mm ABS. Layerheight is 0.2mm. It happens with every infill strategy, it just looks a bit different. Where could I look for the problem? Thanks!
![]()
I have problems with my infill, see the attached picture. In the picture, it already printed 3 layers. You can see the holes in it. What I think is remarkable, the holes are always at the same position, on every layer, which means that it is not a problem of lost steps (otherwise it would not hit the inner circle this perfectly). Of course, "regular" infill does not have to fill the whole layer, but - in my understanding - the top and bottom layer should be completely filled. I'm using repetier host and firmware and slice with slic3er. The settings is 0.4mm, the filament 3mm ABS. Layerheight is 0.2mm. It happens with every infill strategy, it just looks a bit different. Where could I look for the problem? Thanks!
