I'm having an issue with my printer run off of a rambo board with marlin firmware. I had it printing previously, but came back to the printer after a night and wasn't getting any movement, though I could update the firmware on the board. I tried a new board and a new power supply, but still no movement.
I don't need the temperature settings to be functional for the application I have in mind.
Any thoughts on how to test if the issue is with the motors, the board, or the firmware?
What is the best way to test if my motors are fried?
Is there a way to bypass all temperature conditions on printing?
Any suggestions are appreciated, I'm new to this, so let me know what I can clarify to make answering any easier.
Thanks!
I don't need the temperature settings to be functional for the application I have in mind.
Any thoughts on how to test if the issue is with the motors, the board, or the firmware?
What is the best way to test if my motors are fried?
Is there a way to bypass all temperature conditions on printing?
Any suggestions are appreciated, I'm new to this, so let me know what I can clarify to make answering any easier.
Thanks!