I build my 1st prusa a couple of month ago but had to rebuilt recently.
I'm having an issue that my 0.5mm thin wall is having problems nearer to the top of the print.
I've attached a photo showing my orginal 0.5mm thin wall on the left which I was happy with alongside my current thin wall on the right. As you can see my current print is much lower than the orginal and the layers near the top look squased all of sudden.
Anyone know why these layers near the top is all squased on then resolve themselves for the last few layers?
Also why is the cube so much lower than the original? Z-axis has been calibrated and moves 40mm when I instruct 40mm.
And lastly the place where the the z-axis steps to the next level is now in the middle of the side creating a grove, where it used to be on the corner. Any idea what is causing this?
My current nozzle is 0.35mm and my layer hight is set to 0.28mm.
Any help would be appreciated.
I'm having an issue that my 0.5mm thin wall is having problems nearer to the top of the print.
I've attached a photo showing my orginal 0.5mm thin wall on the left which I was happy with alongside my current thin wall on the right. As you can see my current print is much lower than the orginal and the layers near the top look squased all of sudden.
Anyone know why these layers near the top is all squased on then resolve themselves for the last few layers?
Also why is the cube so much lower than the original? Z-axis has been calibrated and moves 40mm when I instruct 40mm.
And lastly the place where the the z-axis steps to the next level is now in the middle of the side creating a grove, where it used to be on the corner. Any idea what is causing this?
My current nozzle is 0.35mm and my layer hight is set to 0.28mm.
Any help would be appreciated.