Hello,
I'm new to the forum and I'm looking for help in problem I have with my RepRap Mendel V2.
After I finished my mechanical assembly I'm in my first!
My configuration is as follows:
Generation 7 1.4
Firmwere repetier 0.83
Host Host repetier Mac 0.56 (53)
For now x-axis and y-axis fondtionne correctly and z as well.
!! The problem is with the "panel print" of repetier host I can not do fontionner extruser and to raise temperature or extrder or the bed!!!
If someone has the same problem or the best solution thank you!
I'm new to the forum and I'm looking for help in problem I have with my RepRap Mendel V2.
After I finished my mechanical assembly I'm in my first!
My configuration is as follows:
Generation 7 1.4
Firmwere repetier 0.83
Host Host repetier Mac 0.56 (53)
For now x-axis and y-axis fondtionne correctly and z as well.
!! The problem is with the "panel print" of repetier host I can not do fontionner extruser and to raise temperature or extrder or the bed!!!
If someone has the same problem or the best solution thank you!