Hello,
I've some problem printing the test cube 10x10, the perimeters is ok, but the infill is ugly.
My configuration is prusa i3 Hot end E3d (Metal) nozzle 0,5 + marlin + slic3r + pronterface and ABS.
i've tried all kind of configuration (extruder multiplier/ e step calibration etc) but without any result, the final dimension of the print are ok but the top layer is higher than print !!!
here is some detail (if it could help):
printing temp 220
fill density 0.4
extruder multiplier 1
layer height 0.5
enclosed you will find some test ( I've one billion of cube…)
many thanks for any help and sorry for my english… :)
Thanks
Alex
I've some problem printing the test cube 10x10, the perimeters is ok, but the infill is ugly.
My configuration is prusa i3 Hot end E3d (Metal) nozzle 0,5 + marlin + slic3r + pronterface and ABS.
i've tried all kind of configuration (extruder multiplier/ e step calibration etc) but without any result, the final dimension of the print are ok but the top layer is higher than print !!!
here is some detail (if it could help):
printing temp 220
fill density 0.4
extruder multiplier 1
layer height 0.5
enclosed you will find some test ( I've one billion of cube…)
many thanks for any help and sorry for my english… :)
Thanks
Alex
