Helllo everyone!
I've finished assemblying my Mendel Tricolour couple months ago and didn't face with this problem until last few days.
Like you can see on the picture, there some displacements on the Y-axis. These shifts take place while printing different models at different speeds.
Even trying same G-code twice, or more, ends up with shifts that could be higher or lower or in different numbers.
I've checked the Y-belt, tighten it up several times and displacements are still there.
Any advices?
I've finished assemblying my Mendel Tricolour couple months ago and didn't face with this problem until last few days.
Like you can see on the picture, there some displacements on the Y-axis. These shifts take place while printing different models at different speeds.
Even trying same G-code twice, or more, ends up with shifts that could be higher or lower or in different numbers.
I've checked the Y-belt, tighten it up several times and displacements are still there.
Any advices?