Hi,
I finally figured out (maybe) why the repetier printbox has always been presented to me backwards (like I am looking from the back of the machine).
I have a Mendel90 and as you know it has the 0,0 at the center, xmin = -100 and xmax = 100, ymin = -100, ymax = 100.
the endstops are at zMAX (at the top of the threaded rod), xmin (at the left) and ymin (in front).
so, the correct values should be 100 for bed front and -100 for bed left. If I enter these values they are ignored and automatically recovered to -100 -100 at the next startup.
what is wrong here?
is there an explanation? am I doing something wrong?
I finally figured out (maybe) why the repetier printbox has always been presented to me backwards (like I am looking from the back of the machine).
I have a Mendel90 and as you know it has the 0,0 at the center, xmin = -100 and xmax = 100, ymin = -100, ymax = 100.
the endstops are at zMAX (at the top of the threaded rod), xmin (at the left) and ymin (in front).
so, the correct values should be 100 for bed front and -100 for bed left. If I enter these values they are ignored and automatically recovered to -100 -100 at the next startup.
what is wrong here?
is there an explanation? am I doing something wrong?