I have a RipRapPro tricolour machine and just commissioning it with the kits own controller. (So learning about it!)
All servos perform as expected using the Pronterface Programme save for the extruder servo (which upon some investigation) will only work for 3 operations, either extrude or reverse before stopping and locking on. This servo will only work again if the controller is switched off and then switched on again. I have tried it several times and it is 3 operations then locking. I have tried disconnecting and reconnecting the computer, but that has no effect. The board has to be powered down. The other servos work fine
Has anybody got any ideas if it is the board or software,or anything else???
Regards
All servos perform as expected using the Pronterface Programme save for the extruder servo (which upon some investigation) will only work for 3 operations, either extrude or reverse before stopping and locking on. This servo will only work again if the controller is switched off and then switched on again. I have tried it several times and it is 3 operations then locking. I have tried disconnecting and reconnecting the computer, but that has no effect. The board has to be powered down. The other servos work fine
Has anybody got any ideas if it is the board or software,or anything else???
Regards