Hello,
I'm building a Rostock and using Ramps 1.4 + DRV8825 Drivers.
The default micro stepping in this board is 1/16 .
DRV8825 support 1/32 micro stepping.
When I configed my rostock to 80 steps per mm it moved half than it should move. When I change is to 160 steps per mm it was good.
It looks like the default micro stepping with these drivers is 1/32 and not 1/16, am I correct?
If i'm wrong, how can I change it to 1/32? because there is not refference about at the Ramps 1.4 page [reprap.org]
I'm building a Rostock and using Ramps 1.4 + DRV8825 Drivers.
The default micro stepping in this board is 1/16 .
DRV8825 support 1/32 micro stepping.
When I configed my rostock to 80 steps per mm it moved half than it should move. When I change is to 160 steps per mm it was good.
It looks like the default micro stepping with these drivers is 1/32 and not 1/16, am I correct?
If i'm wrong, how can I change it to 1/32? because there is not refference about at the Ramps 1.4 page [reprap.org]