Hi all. I am relatively new to reprap and slic3r. So I apologize for my limited knowledge.
If you look at the image here, you will see the one on the right has a solid top portion (this was printed with a makerbot machine). Now look at the one on the left (this was printed with my prusa i3 that I just finished). You will see that the yellow piece, has solid sides but the top is not solid.
Two questions:
1. What setting in slic3r should I adjust to make the top portion print solidly (like on the red piece)?
2. Why would this setting not already be set to do this?
Thanks.
![]()
If you look at the image here, you will see the one on the right has a solid top portion (this was printed with a makerbot machine). Now look at the one on the left (this was printed with my prusa i3 that I just finished). You will see that the yellow piece, has solid sides but the top is not solid.
Two questions:
1. What setting in slic3r should I adjust to make the top portion print solidly (like on the red piece)?
2. Why would this setting not already be set to do this?
Thanks.
