Hello, I am having a problem getting clean corners since I installed my new hot end after my old one jammed. The corners are not comming out smooth. I'm at a loss as to why. I have been playing around with the settings in sli3er/Pronterface but with little sucess. The pieces in the picture were printe at a temperature of 182C with a layer height of .25mm. If anyone has had this issue and knows what was done to correct it I would love to get some ideas since my own experiments don't seem to be making things any better.
Also worth mentioning I also get a lot of stringing when the print head is moving between places to print. For example if printing two of the same object there is a descent amount of tiny stringers that span between both objects. I am using 1.75 filimant and 1mm of retaction. Thanks a lot,
Bob
Also worth mentioning I also get a lot of stringing when the print head is moving between places to print. For example if printing two of the same object there is a descent amount of tiny stringers that span between both objects. I am using 1.75 filimant and 1mm of retaction. Thanks a lot,
Bob