too many retracts when slicing hollow object (2 replies)

Encouraged by Sublime's warrior princess print, I wanted to test slicing an object hollow with support in kisslicer.

My kids lost their yoyo, so I downloaded this from thingiverse.

When I slice it, after the solid layer prints on the bottom, I get an insane amount of destrings for the inside support. I actually stopped printing because I was afraid the extruder would just chew the filament up.

Attached is a screenshot of one of the layers.

I've used something close to the "normal" support from the Tantillus profiles:

; *** Support Settings ***
;
; support_name = Normal
; support_sheathe = 1
; support_density = 4
; support_inflate_mm = 0
; support_gap_mm = 1.25
; support_angle_deg = 75
; support_z_max_mm = -1
; sheathe_z_max_mm = -1
; raft_mode = 1
; prime_pillar_mode = 0
; raft_inflate_mm = 2

I tried sheathing, inflating support, but I didn't see any reductions in the retracts. What settings do you guys use for support for hollow objects?