Hi
I bought a tb6560 based motordriver and hooked it up to my owrk in progress 3D printer
After some testing i found the motor to stall and making weird sound when i changed rotational direction
Since i had allowed for full 1 Amp, i thought this was weird since it shuld be more than strong enough, so I started to messure the voltage over the coils at the stepper motor.
To my supprise I did not get over 1 Volt, while feeding the tb6560 with 12V, and i changed decaymode to both 0% and 100% but did never get more than 1.something Volt
Is this correct or do I have a problem here?
I bought a tb6560 based motordriver and hooked it up to my owrk in progress 3D printer
After some testing i found the motor to stall and making weird sound when i changed rotational direction
Since i had allowed for full 1 Amp, i thought this was weird since it shuld be more than strong enough, so I started to messure the voltage over the coils at the stepper motor.
To my supprise I did not get over 1 Volt, while feeding the tb6560 with 12V, and i changed decaymode to both 0% and 100% but did never get more than 1.something Volt
Is this correct or do I have a problem here?