Printrboard + Arduino IDEversion + Marlin or Repetier (1 reply)

All:
I have a printrboard Rev D and have been running lincomatic's fork of Marlin. To load/manage the firmware I have been used the Arduino IDE 0.22
with a custom Teensy set of drivers. This is all based on the instructions provided with my kit.

I am however getting tired of needing two different versions of the Arduino IDE.

I have tried installing the latest Teensy with the latest Arduino IDE (1.0.X). But
I can not get the lincomatic/Marlin to compile. Nor can I get a straight current version of Marlin
to compile.

I can get Repetier to compile and load (but the behavior is weird (axis reversed, etc.).

So my question for the forum:

Does anyone out there have the newest Arduino IDE working with Printrboard and if so with what firmware?
What changes/mods did you need to make to get it to work?

Any help would be appreciated?