Hello all,
I am exploring the 1/32 microstepping. I will like to know if Ramps V1.4 able to support a 1/32 stepper driver like
[www.pololu.com] or [www.panucatt.com]
after we install the stepper driver to a RAMPS V1.4. I understand we need to set the MS1 MS2 MS3 to correct setting to enable 1/32 stepping. Does anyone know how do we do it on RAMPS ? Software or hardware method ?
In Marlin Firmware, do we need to set any setting in to enable the function ?
With thanks.
I am exploring the 1/32 microstepping. I will like to know if Ramps V1.4 able to support a 1/32 stepper driver like
[www.pololu.com] or [www.panucatt.com]
after we install the stepper driver to a RAMPS V1.4. I understand we need to set the MS1 MS2 MS3 to correct setting to enable 1/32 stepping. Does anyone know how do we do it on RAMPS ? Software or hardware method ?
In Marlin Firmware, do we need to set any setting in to enable the function ?
With thanks.