I have encountered an odd problem with inversion of my prints. I have included a couple pictures to describe the problem. The object on the right is the X-End-Motor bracket and according to the STL screenshot, the motor support should be toward the back of the machine. All objects with symmetry print fine obviously but when it comes to asymmetrical prints all of the features seem to be inverted. The objects are oriented the same in both pictures (according to the LM8UU holders).
This happened to another one of my prints. On the calibration page of the RepRap Wiki under the Print Precision section, there is a precision block that I tried printing. The overhangs printed correctly but the shapes were in the wrong position. The small hexagon was where the large hexagon should have been, triangle was pointing the wrong way etc...
I hope I explained this issue well enough and I bet this is a stupid simple fix. Thanks for the help!
This happened to another one of my prints. On the calibration page of the RepRap Wiki under the Print Precision section, there is a precision block that I tried printing. The overhangs printed correctly but the shapes were in the wrong position. The small hexagon was where the large hexagon should have been, triangle was pointing the wrong way etc...
I hope I explained this issue well enough and I bet this is a stupid simple fix. Thanks for the help!