I've changed the topic. Iam hoping someone can solve this problem.
Hello guys,
I'am a newbie when it comes to building a 3d printer.On the internet i read a lot of information regarding the prusa.There is so much that i am i little confused. At this moment i'am finished with the mechanical part of the build. Now i'am trying to calibrate the printer. I run in to a few problems and i'am hoping that you guys can help me with this.
problem number 1: To calibrate the steps of the motor i need to adjust the firmware in arduino. I can't pick the board i have in the menu! I bought my sanguinololu 1.3a from the internet. On the board it says: tested and programmed. But to adjust the steps i need to know the firmware that is on the board. Is there a program that can retrieve this because when i want to load the changes on to my board i get the following message:
In file included from heater.cpp: 28:
/ pins.h: 674:2: error: # error Oops! Make sure you have 'Sanguino' selected from the 'Tools -> Boards' menu.
no idea what that means, sanguino is not on that list. I also don't know how to get it on the list. At least i can't find it on the internet.
On the internet there isn't a step by step guide on how to install the sanguinololu 1.3a board. I have read a lot on the wiki page about the sanguinololu, I can't really find what i need to do. from a to z
Problem number 2: is that the nozzle of my hotend is jammed. Is there an easy way to clean this?
I hope you guys can help me
Hello guys,
I'am a newbie when it comes to building a 3d printer.On the internet i read a lot of information regarding the prusa.There is so much that i am i little confused. At this moment i'am finished with the mechanical part of the build. Now i'am trying to calibrate the printer. I run in to a few problems and i'am hoping that you guys can help me with this.
problem number 1: To calibrate the steps of the motor i need to adjust the firmware in arduino. I can't pick the board i have in the menu! I bought my sanguinololu 1.3a from the internet. On the board it says: tested and programmed. But to adjust the steps i need to know the firmware that is on the board. Is there a program that can retrieve this because when i want to load the changes on to my board i get the following message:
In file included from heater.cpp: 28:
/ pins.h: 674:2: error: # error Oops! Make sure you have 'Sanguino' selected from the 'Tools -> Boards' menu.
no idea what that means, sanguino is not on that list. I also don't know how to get it on the list. At least i can't find it on the internet.
On the internet there isn't a step by step guide on how to install the sanguinololu 1.3a board. I have read a lot on the wiki page about the sanguinololu, I can't really find what i need to do. from a to z
Problem number 2: is that the nozzle of my hotend is jammed. Is there an easy way to clean this?
I hope you guys can help me