Hello, I just finished the assembly of my first Mendel90 and i have a problem with the installation of the machine.
What I did: 1 - Finished the build.
2 - Turned on the PSU
3 - Installed FTDI USB
4 - Connected the machine via USB
5 - Run Arduino, opened Marlin.ino - changed in configuration.h tab the baud rate to 115200. Did not changed Z_HOME_POS or E_STEPS_PER_MM. Saved.
6 - Run Pronterface, Click Connect. I get this message:
7 - If I press any of the +,-X,Y,Z buttons nothing happens. If I press the Home button the printer goes crazy and tries to push the Y axis with the heatbed off the printer and does not stops when hith the microswitch. The microswitches are working, tested with M119. The fan does not work with M106 - M107.
I am a total noob at this things and i hope someone can help me.
What I did: 1 - Finished the build.
2 - Turned on the PSU
3 - Installed FTDI USB
4 - Connected the machine via USB
5 - Run Arduino, opened Marlin.ino - changed in configuration.h tab the baud rate to 115200. Did not changed Z_HOME_POS or E_STEPS_PER_MM. Saved.
6 - Run Pronterface, Click Connect. I get this message:
I cannot replace the printrunconf.ini file because Pronterface does not creates any file at first run.Quote
Connecting... start Printer is now online. echo:Marlin: 1.0.0 RC2 echo: Last Updated: Jun 8 2013 18:10:37 | Author: nophead echo: Free Memory: 12982 PlannerBufferBytes: 1232 echo:Using Default settings: echo:SD card ok Error:0 : Extruder switched off. MINTEMP triggered ! Error:Printer stopped due to errors. Fix the error and use M999 to restart!. (Temperature is reset. Set it before restarting)
7 - If I press any of the +,-X,Y,Z buttons nothing happens. If I press the Home button the printer goes crazy and tries to push the Y axis with the heatbed off the printer and does not stops when hith the microswitch. The microswitches are working, tested with M119. The fan does not work with M106 - M107.
I am a total noob at this things and i hope someone can help me.
