Filament isn't moving out of nozzle. Extruder pulls out as much as elasticy allows and then it's stuck. There is no plastic coming out when heated to 200 C.
I tried pulling it out by hand, by motor, no go. I could probably use more force, but i already broke a couple of pieces, so i'm a bit vary.
It happened with white, not sure what exactly was i doing, obviously something that ended with reverse, where my with screw empowered extruder managed to snap filament just as it enters the nozzle. I tried pulling it out as per instructions on wiki, but it didn't move, so i was raising temp up to 220 C, by 5 C, while trying to pull it out.
I have some alternative approaches, but they scare me a bit, so i'd rather ask first.
I tried pulling it out by hand, by motor, no go. I could probably use more force, but i already broke a couple of pieces, so i'm a bit vary.
It happened with white, not sure what exactly was i doing, obviously something that ended with reverse, where my with screw empowered extruder managed to snap filament just as it enters the nozzle. I tried pulling it out as per instructions on wiki, but it didn't move, so i was raising temp up to 220 C, by 5 C, while trying to pull it out.
I have some alternative approaches, but they scare me a bit, so i'd rather ask first.