Strange problem with my pursa mendel... (1 reply)

Hello Repraprs

I encounter a strange problem with my pursa mendel (1.4), after i just finished to build it and calibrate it i loaded a 10mm cube for testing (using prontface). its took about 30 minutes until its heated the bed (that not the problem) so i tried to pause and reset the printing. After pushing the pause and the restart button the prontface crashed and since then the printer don't response (using prontface). when i upload the sprinter i do see the green light fleshes meaning there is communication.

I tried to unplug the power and usb cables and to reload the sprinter, but it didn't help...
Any solutions?

Thanks,
Adi.