Hi reprappers,
I wanted to print a cube of 150mm x 150mm x 150mm. I noticed that my print have a leaning tower problem. The product is tilted. I know the common solution is to tune the XYZ axis to a perfect square. But looking at the mendel design with so many parts that can create errors, is there a software way to correct the leaning tower problem ?
I was think if the sli3r or marlin firmware can "offset" the G-code to correct the mechanical errors that is in the mendel design. Anyone got any solution for a perfect print by software approach ?
rgds,
I love reprap
I wanted to print a cube of 150mm x 150mm x 150mm. I noticed that my print have a leaning tower problem. The product is tilted. I know the common solution is to tune the XYZ axis to a perfect square. But looking at the mendel design with so many parts that can create errors, is there a software way to correct the leaning tower problem ?
I was think if the sli3r or marlin firmware can "offset" the G-code to correct the mechanical errors that is in the mendel design. Anyone got any solution for a perfect print by software approach ?
rgds,
I love reprap