Hi all,
I got these nema 17 motors, found that they are 6 wire Japan Servo Company motors.
It is 3 wires per coil with centertap. From my understanding, The setup would work Bipolar if i just ignore the centertap.
The problem I am running into is that when I load the test software, the motors just vibrate. If i put a delay in there, it will move maybe one step, then switch direction. I have them wired as one coil to A, one coil to B, can the coils be backwards?
I have a 50 amp 12V PSU that will run the entire setup(had it laying around at work).
Under the Motor drivers, I have all 3 jumpers in place. Do i need to remove one?
The motors are KH42JM2b1400 DC5 16v 1.2A 1.8 degree /step.
I tried hooking just the motor voltage to 16 volts, didnt make a differance.
Please help!! Printer is fully built, just need to figure out the motor issue.
I got these nema 17 motors, found that they are 6 wire Japan Servo Company motors.
It is 3 wires per coil with centertap. From my understanding, The setup would work Bipolar if i just ignore the centertap.
The problem I am running into is that when I load the test software, the motors just vibrate. If i put a delay in there, it will move maybe one step, then switch direction. I have them wired as one coil to A, one coil to B, can the coils be backwards?
I have a 50 amp 12V PSU that will run the entire setup(had it laying around at work).
Under the Motor drivers, I have all 3 jumpers in place. Do i need to remove one?
The motors are KH42JM2b1400 DC5 16v 1.2A 1.8 degree /step.
I tried hooking just the motor voltage to 16 volts, didnt make a differance.
Please help!! Printer is fully built, just need to figure out the motor issue.