Hello guys and girls!
I am having trouble bridging my prints, it seems that the filament isn't actually touching the layer below it to make the bridge between gaps.
I attached a drawing to show what I mean (viewed from birds eye view, from the top).
When I print a hallow cube, viewed from the top, the left side wall, right side wall and front side wall of the cube make contact with the top layer bridging filament, but the back side wall of the cube, isn't touching it causing the bridge to just fall down because it isn't supported.
Could anyone help me resolve this issue? I tried to play with settings, but I don't think its a settings issue... atleast not bridging settings, maybe my perimeters/width arn't set up properly?
I am using 1.75mm filament with 0.4mm nozzle.
ABS with heatedbed + kapton tape.
Any advice would be helpful! :D
Thankssssss
I am having trouble bridging my prints, it seems that the filament isn't actually touching the layer below it to make the bridge between gaps.
I attached a drawing to show what I mean (viewed from birds eye view, from the top).
When I print a hallow cube, viewed from the top, the left side wall, right side wall and front side wall of the cube make contact with the top layer bridging filament, but the back side wall of the cube, isn't touching it causing the bridge to just fall down because it isn't supported.
Could anyone help me resolve this issue? I tried to play with settings, but I don't think its a settings issue... atleast not bridging settings, maybe my perimeters/width arn't set up properly?
I am using 1.75mm filament with 0.4mm nozzle.
ABS with heatedbed + kapton tape.
Any advice would be helpful! :D
Thankssssss