Hello all,
Trying to put new Megatronics 3.0 at work with Repetier 0.91.
I am getting this situation: moving the extruder motor (E0) with onboard lcd+encoder input everything is OK: motor is rotating correctly.
If I try to do the same in manual mode from Repetier Host, I see changing numbers on LCD, but no movement at all.
If PINS were wrong, motor shouldnt turn at all.
If was a communication problem, digits on display shouldnt move.
Any idea ?
Thank you all
Davide Ardizzoia
EDIT: MIN_EXTRUDER_TEMP could be responsible for this behaviour ? Meaning that this safety is working only if printer is operated thru USB connection ?
Trying to put new Megatronics 3.0 at work with Repetier 0.91.
I am getting this situation: moving the extruder motor (E0) with onboard lcd+encoder input everything is OK: motor is rotating correctly.
If I try to do the same in manual mode from Repetier Host, I see changing numbers on LCD, but no movement at all.
If PINS were wrong, motor shouldnt turn at all.
If was a communication problem, digits on display shouldnt move.
Any idea ?
Thank you all
Davide Ardizzoia
EDIT: MIN_EXTRUDER_TEMP could be responsible for this behaviour ? Meaning that this safety is working only if printer is operated thru USB connection ?