Still no movement (no replies)

Here is the rundown...
The machine worked a few weeks ago and now it does not.
Since then the motherboard and the power supply have been replaced.
I have tried several versions of the firmware with temp checks commented out.
I have ran the motor test code 1.4 that every one is talking about the board flashes and then there is no movement.
The printer connects to pronterface and the machine thinks it is printing.
When I ask it to move 10mm or home it thinks it moved. it gives me new xyz
When I send M119 it says all end stops are "open"
With the machine off I unplugged each motor and plugged in an LED to the ends of the wires, moved the motors manually and they all light up. meaning the wiring from the motor to the board is good right?
I cannot feel a difference in resistance if the machine is on and "printing" or if it is off. Should I be able to tell a difference whit these little steppers?
I checked the pin configuration and that seems to be correct for Motherboard 301.

Please help. What else can I check and how can I check it?

Thank you!