Hi all, I have finished building my Ormerod yesterday and I have already printed some pieces (found no hard problems apart the bed leveling which is a tedious process, if done manually, or simply not working, if done automatically).
Now I have loaded a good number of gcode files I would like to test and I have found that when I issue the M20 command (or a click the SD->print function on pronterface) only the first 24 files (ordered by creation time) are listed.
Is anyone of you experiencing the same problem?
I'm using the latest firmware:
FIRMWARE_NAME:RepRapFirmware FIRMWARE_VERSION:0.57a ELECTRONICS:Duet DATE:2014-01-16
Thank you, Andrea.
Now I have loaded a good number of gcode files I would like to test and I have found that when I issue the M20 command (or a click the SD->print function on pronterface) only the first 24 files (ordered by creation time) are listed.
Is anyone of you experiencing the same problem?
I'm using the latest firmware:
FIRMWARE_NAME:RepRapFirmware FIRMWARE_VERSION:0.57a ELECTRONICS:Duet DATE:2014-01-16
Thank you, Andrea.
